top of page

INSTALLATION INSTRUCTIONS

INSTALLATION GUIDE FOR POLLENGUARD TM NANOFIBER TM FLYSCREEN

1. REMOVE SPLINE & EXISTING MESH (if re-meshing).

2. LAY FRAME ON A FLAT SURFACE AND DRAPE POLLENGUARD MESH OVER IT.

3. CUT THE POLLENGUARD MESH WITH 20mm OVERLAP ON ALL FOUR SIDES.

4. APPLY NEW SPLINE (DO NOT USE THE OLD). NEW SPLINES CAN BE PURCHASED FROM ANY HARDWARE STORE, FOAM SPLINE RECOMMENDED.

5. NEW SPLINE THICKNESS SHOULD BE THE SIZE OF YOUR FLYSCREEN’S SLOT.

6. START SPLINING APPROXIMATELY 90mm FROM ONE CORNER TO ALLOW STRETCHING AS YOU GO AROUND THE FRAME.

7. USE SPLINE ROLLER TO PUSH THE SPLINE INTO THE SLOT.

8. TRIM THE EXCESS SPLINE AND MESH WITH A SHARP STANLEY KNIFE OR BLADE.

​

​

Screen Shot 2023-05-03 at 7.06.03 pm.png

CLEANING INSTRUCTIONS

CLEANING GUIDE FOR POLLENGUARD TM NANOFIBER TM FLYSCREEN

 

USE MILD pH-NEUTRAL DETERGENT AND WIPE THE SCREENS GENTLY WITH A MICROFIBERGLOVE OR CLOTH FOLLOWED BY LOW PRESSURE RINSE.

 

POLLENGUARD FLYSCREENS SHOULD BE CLEANED TWICE YEARLY, ONCE BEFORE THEPOLLEN SEASON AND ONCE, AFTER THE POLLEN SEASON.

 

REFER TO OUR POLLEN CALENDARS FOR YOUR CITY.

bottom of page