DIY INSTALLATION INSTRUCTION

REMOVE SPLINE & EXISTING MESH

(if re-meshing).

CUT THE POLLENGUARD MESH WITH 20mm OVERLAP ON ALL FOUR SIDES.

​

​

NEW SPLINE THICKENSS SHOULD BE THE SIZE OF YOUR FLYSCREEN’S SLOT.

​

​

USE SPLINE ROLLER TO PUSH THE SPLINE INTO THE SLOT.

LAY FRAME ON A FLAT SURFACE AND DRAPE POLLENGUARD MESH OVER IT.

APPLY NEW SPLINE (Do not use old spine). NEW SPLINES CAN BE PURCHASED FROM ANY HARDWARE STORE, FOAM SPLINE RECOMMENDED.

START SPLINING APPROXIMATELY 90mm FROM ONE CORNER TO ALLOW STRETCHING
AS YOU GO AROUND THE FRAME.

TRIM THE EXCESS SPLINE AND MESH WITH A SHARP STANLEY KNIFE OR BLADE.